Hi I converted at 320mb video file to mpeg and got a 100mb file that will not display sound or video. The setting I used were - MPEG-2 512x384 23.976fps VBR 1150kbps, Layer-2 44100Hz 192kbps. any ideas folks.
Hi GSpot reports required codecs are installed and I am able to play the original avi file. My other settings are Video Stream type - mpeg-1 video size 512 x 384 aspect ration 1:1(VGA) Frame Rate 23,976 fps Rate control mode 2-pass VBR(VBR) VBR buffer size o Motion search precision Normal Audio MPEG-1 Audio layer II sampling at 44100 channel stereo bitrate 192
Hi Dela, did not notice any bad frames but I will try to decompress the audio to see if it help. Thanks for advice
Well one thing I can spot staight away...your resolution is incorrect for vcd (as your creating an mpeg1) Pal (25fps) = 352 x 288 Ntsc/Film (29 or 23.976) = 352 x 240 Also your Bitrate should be cbr (constant 1150) NOT vbr (variable 1150) And if were being REALLY picky ) Your audio should be 224kbs not 192 (but this rearly makes a difference) Are you going for vcd or svcd as i noticed you say mpeg2 in the first post but mpeg1 in the second ? Regards Acheron
Ah ye, I didnt even check that out at all, lol The reason for that is, TMPGEnc takes the frame size of the source video when it is loaded in, in fact i better add that to the TMPGEnc problems thread. As for audio 192kb/s is actually standard even though nero might tell you otherwise!
Nope 224 kbs @ 44.1 khz is the audio standard for vcd.. ) Edit: I just checked were both wrong & right Vcd 1.1 spec is: 224 kbit/sec Vcd 2.0 spec is: 128,192,224 or 384(!) kbit/sec All at 16 bit,44.1k Sampling rate. )
