desoldering on a 1.0

Discussion in 'Xbox - Hardware mods' started by joho5, Jan 19, 2007.

  1. joho5

    joho5 Member

    Joined:
    Jan 12, 2007
    Messages:
    51
    Likes Received:
    0
    Trophy Points:
    16
    what is the best / safest way to desolder the holes on a version 1.0 mobo? braid or sucker, or any other ideas. i have never desoldered anything is why i am asking. any simple instructions or information will be much appreciated.

    thanks
     
    joho5, Jan 19, 2007
    #1
  2. ModdaMIke

    ModdaMIke Guest

    i use the braid and i have never had a problem
     
    ModdaMIke, Jan 19, 2007
    #2
  3. joho5

    joho5 Member

    Joined:
    Jan 12, 2007
    Messages:
    51
    Likes Received:
    0
    Trophy Points:
    16
    just heat one side up and put the braid on the other and it melts into it?
     
    joho5, Jan 19, 2007
    #3
  4. ModdaMIke

    ModdaMIke Guest

    thats what i did but you might get some heat damage, it wont be too bad
     
    ModdaMIke, Jan 19, 2007
    #4

Share This Page