evox loading default ms dash

Discussion in 'Xbox - General discussion' started by dmarkow, Jul 15, 2003.

  1. dmarkow

    dmarkow Member

    Joined:
    May 26, 2003
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    11
    I followed seamonkey's guide to the dot but i'm having problems accessing the default dash from within evolutionx. I'm using the latest version of evolutionx, and the D6 version of evox bios, though i'm not sure if it's the ejectfix or not, if that matters. It shows the xbox dashboard, but then just locks up. Any ideas?
     
    dmarkow, Jul 15, 2003
    #1
  2. FrEnZy

    FrEnZy Member

    Joined:
    Jul 10, 2003
    Messages:
    19
    Likes Received:
    0
    Trophy Points:
    11
    I've tried lots of methods too, tried to boot into my old MS dashboard with evox but its no use!
    Everytime i hav to backup my evox C: partition and copy the backup of the original xbox dashboard to use it.
    Is there no other way to make evox load ms dashboard or boot MS dashboard without errors.
     
    FrEnZy, Jul 15, 2003
    #2
  3. Matador

    Matador Regular member

    Joined:
    Jul 3, 2003
    Messages:
    344
    Likes Received:
    0
    Trophy Points:
    26
    all you need is the original .xtf files and xboxdash.xbe.If you are using Reloaded then you must sign xbe..
    ******************************************
    make a copy of xboxdash.xbe and ftp over to PC.once you done the =*...x.f.t. trick then copy the xbe but rename it to default.xbe and put it in the E:\ dir. then just rename the originals xtf files to xft...Configure evox.ini file for MSdash to e:\default.xbe then reboot and run..if using RELOADED then u must Sign..
     
    Matador, Jul 15, 2003
    #3

Share This Page