Few issues with xeno....Install the chip, works fine, close the cube up, and ERROR!

Plain and simple...after spending quite abit of time screwing down every last screw (yes I tested before hand and it worked fine) I tested it again, and it would no longer boot backups of any kind.

Any idea whats going on? I dont feel much like opening it and examining for a problem just yet and figured i would post about it first.



Sidenote:
I hot glued the chip down before soldering to keep it in place and so the marks are dead on the solderspots and there to stay. so i dont think it couldve gotten loose...

 

Decided to pay attention to the lights and noticed that it starts red, flashes once, then turns to green. acts like its going to load. then turns back to red and dies out...

And no. It isnt the media discs used.

 

Nevermind..Let this topic die. Tried to remove the chip since im guessing it wasnt soldered right and ended up tearing the drive`s board itself up. So no more cube.