I just installed the Xecuter 2.6 CE mod chip into my V1.6 XBox. I flashed the BIOS with a Verbatim DVD using the Xecuter2_Build.4978.03_512k BIOS. After the flash, the XBox shut off like it is supposed to. When it starts up again, it is only a blue screen. Based on the tutorials, I don't think this is supposed to be like that. The eject tray also flashes red and green, which again, doesn't look good. I also need some help installing the EvoX Dashboard. I have burned the evoX v.183285 iso to a Verbatim DVD and rebooted the XBox, but nothing loads. If anyone could give me some help, that would be great.
is anything on this blue-screen or is it blank? what flash tutorial did you follow?and where did you get the bios from?
Sorry, I should have updated my post earlier as the situation has changed since then. I fixed the BIOS issue by loading FlashBIOS 3.0.1 on Bank 2 and the EvolutionX M8 Bios_v1.6 on Bank 1. However, when I try to run the AID autoinstaller on a cold boot, my XBox tries to load it (I see a screen with the typical XBox logo with AID 3.04 on the bottom of the screen). After about 25 seconds my XBox goes to a blue screen, but it does not shut off. I've had some help from others that I did not get a chance to try yet. This was to avoid the use of the EvolutionX M8 Bios_v1.6 BIOS file and try the X2 5035 V6 Plus BIOS and then load the AID Disc. I also was instructed to not use a 1GB dummy file in the AID DVD (Verbatim). If you have any other help that would be great.
there should be no dummy file on the aid disc it shouldnt be larger than 800mb just extract the AID image and burn with image burn...
