Invalid Block Address Error

Discussion in 'Nero discussion' started by gary345, Mar 6, 2010.

  1. gary345

    gary345 Member

    Joined:
    Jun 26, 2005
    Messages:
    7
    Likes Received:
    0
    Trophy Points:
    11
    Is it the speed thing problem?
    Should i set slower?

    The following is the error message:

    [​IMG]

    Is it alright to use the same dvd dics non-rewriteable to burn again? Just now right before the error pops out, it stuck at 16%.
     
    Last edited: Mar 6, 2010
    gary345, Mar 6, 2010
    #1
  2. attar

    attar Senior member

    Joined:
    Jun 17, 2005
    Messages:
    11,147
    Likes Received:
    41
    Trophy Points:
    128
    Newer firmware listed here.
    http://www.firmwarehq.com/Samsung/SH-S182D/files.html

    I don't know - but I don't use multisession.

     
    attar, Mar 6, 2010
    #2
  3. gary345

    gary345 Member

    Joined:
    Jun 26, 2005
    Messages:
    7
    Likes Received:
    0
    Trophy Points:
    11
    So am i suppose to install the lastest firmware, version SB07? Thanks you.
     
    gary345, Mar 7, 2010
    #3
  4. attar

    attar Senior member

    Joined:
    Jun 17, 2005
    Messages:
    11,147
    Likes Received:
    41
    Trophy Points:
    128
    You're using good disks (Verbatim?)- so not much to be gained by switching.

    You could try saving the output from Nero to the HDD and use a good burning program like ImgBurn.

    If that doesn't help, then use the latest firmware - my own preference would be to update the firmware as a last resort because of the inherent risk of something going wrong as the drive is flashed.

     
    attar, Mar 7, 2010
    #4

Share This Page