just used chip off a old box just need some help

Discussion in 'Xbox - Hardware mods' started by MaNiAcUk, Dec 4, 2008.

  1. MaNiAcUk

    MaNiAcUk Member

    Joined:
    Jul 16, 2007
    Messages:
    11
    Likes Received:
    0
    Trophy Points:
    11
    have installed a executor 3ce chip out of a dead xbox to mates new xbox now i know i need to back up the orginal hard drive c and e drives before installing my new 120gb drive in it i ftp in and go to copy drives local then it freezes up the ftp conection and wont down load am i doing something wrong?

    i dident re flash the bios is that needed?

    any help would be great thanks.
     
  2. S10MAN

    S10MAN Member

    Joined:
    Nov 21, 2008
    Messages:
    94
    Likes Received:
    0
    Trophy Points:
    16
    Try xboxhdm . Reflashing the modchip wont do much other than just reflashing it . Unless its a 1.6 . Then you would have different problems .
     
  3. S10MAN

    S10MAN Member

    Joined:
    Nov 21, 2008
    Messages:
    94
    Likes Received:
    0
    Trophy Points:
    16
    Sorry i meant xplorer360 . My mind was elsewhere .
     
  4. cvick14tx

    cvick14tx Member

    Joined:
    Dec 18, 2008
    Messages:
    15
    Likes Received:
    0
    Trophy Points:
    11
    You dont have to back up the C: and E: if
    you dont want to. Just put the new drive in and
    run slayer 2.7 and that will build the hard drive for
    you. If you really want the C: and E: then use the
    utility that was suggested above.
     

Share This Page