Power Calibration Area Error

Discussion in 'DVDR' started by jeditig, Dec 28, 2003.

  1. jeditig

    jeditig Member

    Joined:
    Sep 22, 2003
    Messages:
    17
    Likes Received:
    0
    Trophy Points:
    11
    I have pinnacle Instant CD DVD. I am trying to put some mpegs onto a DVD. I have an aomagic generic DVD-R burner. The programs reads the blank DVD media, but when it goes to write, it brings up the Power Calibration Error. I have seen posts about ASPI, which I did but I have all IDE devices. I read another post about maybe not enough power to the drive.

    PLEASE HELP.

    PS, I previously had a Pioneer A05 that stopped reading DVD /CD, but would recognize the DVD-r, CD-R, it would not burn. I thought the drive went bad so i bought another. Any suggestions??

    Thanks
     
    jeditig, Dec 28, 2003
    #1
  2. wardair

    wardair Member

    Joined:
    Oct 24, 2003
    Messages:
    32
    Likes Received:
    0
    Trophy Points:
    16
    i have a power calibration error on my yamaha f1 cd burner and have no clue as to what causes it so i took out the drive
    good luck
     
    wardair, Dec 30, 2003
    #2

Share This Page