tmpgenc encoding problem -PLEASE help

Discussion in 'DVDR' started by ladys, Jun 27, 2003.

  1. ladys

    ladys Member

    Joined:
    Jun 25, 2003
    Messages:
    3
    Likes Received:
    0
    Trophy Points:
    11
    I have used TMPGEnc-2.5 to encode an avi into mpeg to burn to Vcd. After leaving it on all night (49 minute file), I found that the video is fine but there is no sound. There was sound on the original (mpeg 3 layer). Can anyone tell me why this may have hapened. I am very new to encoding and trying to make a vcd.
    Thank you.
     
    ladys, Jun 27, 2003
    #1
  2. Oriphus

    Oriphus Senior member

    Joined:
    May 31, 2003
    Messages:
    4,354
    Likes Received:
    0
    Trophy Points:
    116
    Confusing aint it!! Seem happens to me all the time. I gave up on it!
     
    Oriphus, Jun 27, 2003
    #2
  3. anosis

    anosis Guest

    ladys,

    What did you enter in the video and audio file section? Since you do not have your audio demuxed (extracted) from your original AVI file, you need to put the AVI file in both the Video and Audio selection.

    If that still does not work, you would have to use some other software to demux your sound from your AVI file first into a WAV and then go though the whole re-encoding process again.

    Hope this helps
     
    anosis, Jun 27, 2003
    #3

Share This Page