Ok Heres What I have Gamecube Gamecube Broadband Adaptor 10Ft Crossover Cable Phantasy Star Online Disc Memory Card Ok heres what py PSO settings Are: IP:192.168.0.7 Subnet Mask:255.255.255.0 Gateway: 192.168.0.1 Primary DNS:192.168.0.1 Secondary DNS: Blank Ok I connect the Crossover Cable to the BAck of the PC and into the Gamecube, From there I run the PSUL -s so I get the DOS screen waiting for connection, I boot Up PSO and go through all the menus just using fake key and access codes then try to load. The little Monitor down in the taskbar goes from a navy blue to being disconnected, then quickly reconnects and gos to limited. the PSUL program does nothing, it just sits there and the PSO gives the same exact error message it always does. anyone have any ideas as of whats wrong? Thanx
for one thing or pso ip address settings arent correct it should be 192.168.32 i beleive also ur have to put in a cetain ip for i=ur computer
Ok, I Think I may have Figured It out, I used the settings As noted In the Forum as Well Changed the Computer Settings, I Did get a COnnection but PSUL spit out the following: Served DNS Query From 192.168.1.32.... Does that Mean it Saved it or what? Thanx
Ok Figured out now heres the next Question, Anyone know of any rippers/streamers that actually work? wand where I can get it? so far I have tried: GCN-Ripper (Nice Atempt but so many Fails means crappy program) Reliable NGC Disc Streamer (Reliable at doing nothing!, got everything up to where it started to rip, then it sat, and sat, and sat for about an hour not 1 MB was even uploaded) GCOM (looked nice up until the point you click on the browser and go to the web address and theres nothing to download) Anything else I could try? Anyone know of a method that actually works out there? Thanx
nm, I answered My own Question, Cubesoft Pheonix is by far the best and everything worked flawlessly after tesing it out. Now that I have accomplished that I can move on to modding the Console
