Unable to Burn A movie after upgrading CloneDVD2 and AnyDVD 6.0.9.9.

Discussion in 'DVDR' started by rilke, Dec 26, 2006.

  1. rilke

    rilke Member

    Joined:
    Jul 10, 2004
    Messages:
    14
    Likes Received:
    0
    Trophy Points:
    11
    Since upgrading CloneDVD2 to 2.9.0.2 and AnyDVD to6.0.9.9., I am unable to burn a movie. My burner is Plextor PX-716UF. Earlier, after
    burning a movie that worked, an audio comment would stated that the
    copy was unsuccessful. However, it always played on my DVD player.

    Do you recommend that I remove one or both of the programs and
    re-install them
     
    rilke, Dec 26, 2006
    #1
  2. ireland

    ireland Active member

    Joined:
    Nov 28, 2002
    Messages:
    3,451
    Likes Received:
    15
    Trophy Points:
    68
    ireland, Dec 26, 2006
    #2
  3. ireland

    ireland Active member

    Joined:
    Nov 28, 2002
    Messages:
    3,451
    Likes Received:
    15
    Trophy Points:
    68
    new anydvd just out
    6.1.0.0 2006 12 26
    - New: Added support for new versions of the SONY Arccos protection
    to the option to remove "Protection based on unreadable Sectors"
    - Fix: Very small Arccos protected titles were not treated correctly
    - Fix: "Too many Navpacks" error with AnyDVD ripper
    - Note: It is recommended to use elby CloneDVD to rip instead of the
    AnyDVD ripper, even if you prefer to use another program to compress
    and/or burn (Set elby CloneDVD to DL burning and copy files to
    harddisk). elby CloneDVD is available at http://www.sylsoft.com
    - Some minor fixes and improvements



    http://static.slysoft.com/SetupAnyDVD.exe
     
    ireland, Dec 26, 2006
    #3

Share This Page