used read buffer?

Nykid · Jul 26, 2005

wondering , i see it in decrypter and in nero, what exactly does it do?

creaky · Jul 26, 2005

snippet from http://club.cdfreaks.com/showthread.php?t=113517 -

Nero normally shows two buffers, the Software read buffer (which is typically sized from around 40-80Mb, automatic or settable in preferences ultrabuffer, and the drive buffer (typically a 2Mb buffer).

At the start of a burn, the software buffer (which I think is the "used read buffer") is tanked up to 100% by prereading the first files (or the first part of the file) to be burned.

Now in the buffer dance that follows, the writer fills it's buffer from the software one, and Nero tries to keep the buffer filled, until the end of the burn, when the buffer will drain out as it completes.

If the writer draws data faster than it can be read into the buffer, the buffer will deplete - and when both buffers hit zero (other than in the final rundown) then you either have an underrun recovery ("BurnProof") if any underrun recovery is supported and enabled, or a buffer underrun and a failad burn (coaster) if it was not supported and enabled.

The read buffer should ideally flicker around the 99% (used) during a burn - if it repeatedly depletes, then either use a lower burning speed, or take measures to improve the read transfer rate:

1. Defragment the hard drive
2. Ensure that both the HD and the writer are in DMA mode
3. Avoid putting the writer on the same IDE cable as the drive you are reading from
4. Avoid putting any additional load on the system while burning

Firmware is, effectively, the operating system in the drive - a good firmware update (flash), can add recognition of other media identities (better or faster burn on them), but a bad update (wrong or failed) can kill the drive - though there are backdoor rescue methods for many drives.

The key to firmware updates, always read the instructions - DOS means BOOTED TO DOS, a DOS Windows is NOT GOOD ENOUGH - though most firmware updates now run in Windows anyway.
And of course, don't try to update when there is an above average risk of power failure.
Click to expand...

Nykid · Jul 26, 2005

i have a new laptop and my used buffer drops down periodically.

creaky · Jul 27, 2005

did the above info help ?. if not have you some logfile info of sorts ?

Nykid · Jul 27, 2005

I defraged my drive I'll try and burn a movie tomorrow.

Log in or Sign up

used read buffer?

Nykid Regular member

creaky Moderator Staff Member

Nykid Regular member

creaky Moderator Staff Member

Nykid Regular member

Share This Page

Log in or Sign up

used read buffer?

Nykid Regular member

creaky Moderator Staff Member

Nykid Regular member

creaky Moderator Staff Member

Nykid Regular member

Share This Page

Useful Searches