hi all, i got a little problem i have been converting avi to vob using winavi and burning with nero and this is working fine only takes about an hour! but the problem is there is a slight jump all the way through the movie it more noticeable when somones running or the camera angle pans round fast is there anyway to stop this ive tried burning at all the speeds i can 8x 4x 2x 1x and still got the same problem i can stll watch the movie but its annoying can anyone help!
Hi im not 100% sure but it could be the media you are burning to also make sure you dont have a heap of programs running in the background while burning.What media are you using?what dvd writer are you using? and try updating firmware all these things are simple and when things are going bad its always good to go back to the basics. Any way hope any of the info helps you out good luck!!
Hi.. I've been using WinAVI a LOT this week on a project I'm doing in DVDLab Pro, and haven't had the singlest problem... have you tried pre-viewing the project after it's compiled with a software program such as WinDVD? Perhaps you can see if it's the media chosen. Although I must confess I haven't seen a system so picky with the media as DVD... you have to be very careful about that... it's amazing
You may want first to ascertain what is going wrong by checking each step of the burning process: 1) check original avi 2) check after conversion 3) burn to harddisk first and check 4) burn to dvd and check
