X-ecuter 2.2 lite + : Eject button flashing red/green

Discussion in 'Xbox - General discussion' started by Da_Cobra, Sep 17, 2003.

  1. Da_Cobra

    Da_Cobra Member

    Joined:
    Sep 16, 2003
    Messages:
    31
    Likes Received:
    0
    Trophy Points:
    16
    First let me say that I already searched alot of forums.
    Alot of ppl seem to have this problem after installing a chip.
    I also installed a chip and aligned it perfectly, so that's not the problem.
    but the problems began after I flashed the bios with an evolution X bios with a CDrw.
    if I turn my chip off then my xbox startsup normally, so it isn't also a hardware problem.

    Now I have 2 questions :
    1) can someone confirm that it's indeed a bad bios that I flashed in my chip?
    2) can I flash it again without a programmer or do I need to order one?

    thanx in advance for any replies
     
    Da_Cobra, Sep 17, 2003
    #1
  2. ozy

    ozy Regular member

    Joined:
    Apr 17, 2003
    Messages:
    614
    Likes Received:
    0
    Trophy Points:
    26
    I'm not sure if this is the problem but mine flashes red and green when I have'nt plugged the AV plug into the back and connected it to the T.V. When I insert a backed up game I have to restart the xbox for the game to play.
     
    ozy, Sep 18, 2003
    #2
  3. Da_Cobra

    Da_Cobra Member

    Joined:
    Sep 16, 2003
    Messages:
    31
    Likes Received:
    0
    Trophy Points:
    16
    I solved my problem : I needed to reflash the chip with the X-ecuter bios.
    here's how I did it, without a programmer :

    First let me say I had the luck that a friend of mine also ordered a chip and didn't installed it yet. So I put his chip in my Xbox, start it up, when the cromwell screen appeared I switched chips and then I put the bios cd-rw in the drive and it reflashed my chip with no problems :D
     
    Da_Cobra, Sep 18, 2003
    #3

Share This Page