x-ecuter lite 2.2 flashing green and red

Discussion in 'Xbox - General discussion' started by quik, Dec 15, 2003.

  1. quik

    quik Member

    Joined:
    Dec 15, 2003
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    11
    i have the x-ecuter 2.2 lite. after installation it asked me to update the bios. updated it with cromwell 1.6a. now when the chip is enabled it turns on and off 3 times ending with the eject button flashing green and red. can some one tell me what the problem is?
     
    quik, Dec 15, 2003
    #1
  2. djboogie

    djboogie Regular member

    Joined:
    Oct 26, 2003
    Messages:
    816
    Likes Received:
    0
    Trophy Points:
    26
    is it connected to your pc (ie network)
    if so unlpug it
    then try again, switch it off , not reset, then back on
     
    djboogie, Dec 15, 2003
    #2
  3. smokes

    smokes Guest

    Mine is doing that too now. I'm using an xecuter 2.3 lite PLUS and it starts up, blinks green 3 times every few seconds, then ends w/ the red/green/red/green or sometimes just stays yellow...how do I fix this? Should i continue to scrape the DO point to open it up, or what is wrong!?
     
    smokes, Dec 16, 2003
    #3
  4. quik

    quik Member

    Joined:
    Dec 15, 2003
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    11
    no i dont hav it connected to my pc.
     
    quik, Dec 17, 2003
    #4

Share This Page