x3 help

Discussion in 'Xbox - Hardware mods' started by Seriall, Apr 17, 2005.

  1. Seriall

    Seriall Member

    Joined:
    Apr 14, 2005
    Messages:
    8
    Likes Received:
    0
    Trophy Points:
    11
    I recently installed an x3 mod with the x3 control panel. And then I went through all of the MIRC stuff to get my bios. My problem is that my mod install is proper {i'm guessing} and when I flash the bios it looks like it was done properly, but then after it shuts of and I turn it back on it flashes the green and red light.

    Please Help, any advice would be appreciated
     
    Seriall, Apr 17, 2005
    #1
  2. Achilles3

    Achilles3 Guest

    Sounds like you flashed it right. Try turning your Xbox on with the EJECT button. If it works then no problems, whenever you turn on your Xbox using the POWER button, you have to just slighty tap it and quick about it. Don't tap it for too long or it will give you the FRAG error.
     
    Achilles3, Apr 17, 2005
    #2
  3. ChipMasta

    ChipMasta Regular member

    Joined:
    Jul 24, 2005
    Messages:
    229
    Likes Received:
    0
    Trophy Points:
    26
    this is what exactly happened to me. i had to reflash my chip and it worked fine. and also chech the dO wire.
     
    ChipMasta, Jul 24, 2005
    #3

Share This Page