Hya. I ve got some probs with it. I installed it and had to make grey wire longer in order to solder it at the back of mobo. So now when I turn it on with chip active (blue led on) cromwell comes up and tray opens. but i couldnt flash it with cd. When chip is disabled and 4th switch is on (flash protection) there is no frag. What do you think is the problem? Is it D0? Thanks in advance.
I have the same problem so I tried to flash via the PC x2bm erased the bios but froxe up writing the new one ... If I figure out a solution I will post it here
my m8 is having exactly the same problem as you guys! hmmm we tried a couple of things e.g. re-installation and burn the new bios to a cd but still didnt work. will let u know if we get a solution
FRAG is a continous (F)lashing of (R)ed (A)nd (G)ren. After installing you chip (Xecuter 2.2 Pro) disable it (No blue led) and put 4th switch to on. Now turn you xbox. and it should flash red and green. And when you activate chip (blu LED is on). Now if you turn on xbox, Cromwell will come up and dvd tray open.
Yes! Actually what happened for me is I installed the Chip turned on the machine mod disabled and it worked fine, turned the machine with the mod enabled it came up cromwell and wanted the cd. I put in the cd but it would not work so we decided to try the PC method, hooked up, all was good, tried to flash with x2bm v2.0 beta 7, it erased the bios and froze up 13% writing with several differnet bios. So I tried different x2bm versions, v1.1 froze up as well, v1.0 erased, wrote but failed verification. now when it is hooked up to try to power up with the mod enabled it tries to boot 3 times all 3 times the mod light comes on and goes off then the power led on the xbox flashes red and green and does not boot.
See, when I try to flash it it goes fine while writing, and at the end it says cannot verify. What can I do?
I can write with x2bm v1.0 but with that same problem it fails verification._X_X_X_X_X_[small]Phil C[/small]
