Xecuter 2.3 lite + install problem

Discussion in 'Xbox - General discussion' started by fklentz, Dec 24, 2003.

  1. fklentz

    fklentz Member

    Joined:
    Dec 24, 2003
    Messages:
    6
    Likes Received:
    0
    Trophy Points:
    11
    Brand new 1.5 XboX, just installed mod chip, followed all directions available. No mater what position enable/disable switch is in it always boots to M$ bios. I get the two blue led's on the mod, the external switch is green when enabled and red when disabled, the green led on the mod is on when set to disable and off when set to enable. If I disconnect the usb power the unit does the three boot red/green forever act. Any help would be greatly appreciated.
     
  2. MikeDDR

    MikeDDR Regular member

    Joined:
    Oct 22, 2003
    Messages:
    370
    Likes Received:
    0
    Trophy Points:
    26
    When the chip is enabled have you tried playing a backup game? Because if you flashed the chip and don't install a new dashboard then it will load to M$ dashboard with the possibility of playing backups!
     

Share This Page