Xecuter 2.3 problems - please help

Discussion in 'Xbox - General discussion' started by Abysmal, Dec 12, 2003.

  1. Abysmal

    Abysmal Guest

    I have just moded my xbox with the new Xecuter 2.3 lite chip. When I boot the unit with the modchip on I get no video, and the dvd drive opens.. I found out on the net that I have a newer xbox and that the cromwell bios on the executer won't work with it and display any video.. So I download slayers 2.5 install and put the disk in the drive.. now I still have no video and the power light flashes red and green..

    What have I don and how can I correct it??

    Thanks in advance for the help..
     
  2. smokes

    smokes Guest

    Ok, I hope anyone who has been helped with this before will respond! I hope i get like 10 responses!

    I have the XECUTER 2.3 LITE PLUS chip and a version (I believe...) 1.4 xbox...idk I bought it a week ago.

    I scraped and I scraped and I scraped the DO point, I see copper not metal I am pretty sure I got it good.... I have the chip on enable....unprotected....and bank 1 like the guy at my store said it should be. Before I would get 2 blue lights on the xbox, and 1 green light on the switch w/ enable/disable etc, and the xbox just loads up normal, everything works fine, but it loads up w/ m$ bios.

    Now, it either blinks green for 3 times every few seconds, then goes green/red/green/red or just a steady yellow...or I can take off the chip and it works......

    What do I have to do! I have moved the chip around a MILLION times.... it seems like its gettin somewhere new since it doesnt load up xbox normal bios when the chip is on, and when its off its fine, but I NEVER get the green LED4 light on the chip to come on. No matter what I do. Someoen said something about scraping the pin on the modchip that plugs into DO?? I'll try that, along with the tinfoil plan, but what is some more advice! My brother is home in 2 days and Im trying to do this for him for xmas. I already did my own chameleon modchip, so I have some backround in the topic. Please help!!

    P.S. My LPC points are all open, I didnt have to de-solder anything...if that could be anything. Also, I have some little gold cylinder pins from a chameleon modchip left over that fit in the lpc points if that could help at all...
     

Share This Page