Xenium Gold Chip causes controller failure

Discussion in 'Xbox - Hardware mods' started by triniboy1, Sep 11, 2006.

  1. triniboy1

    triniboy1 Member

    Joined:
    Sep 11, 2006
    Messages:
    3
    Likes Received:
    0
    Trophy Points:
    11
    Need some help!

    I installed a Xenium Gold chip into my Xbox v1.6 and when the xbox was turned on, the OS booted up, but the controller wouldn't work. The LED on the chip was red when booting and then turned off. When the chip was disconnected, the controller worked again...

    Any ideas?
     
    triniboy1, Sep 11, 2006
    #1
  2. theridges

    theridges Guest

    are you using the SP Adapter?? check all the arms if you are....
     
    theridges, Sep 12, 2006
    #2
  3. triniboy1

    triniboy1 Member

    Joined:
    Sep 11, 2006
    Messages:
    3
    Likes Received:
    0
    Trophy Points:
    11
    No, I'm not using the adapter... I'm using the pin header and the LPC rebuild.
     
    triniboy1, Sep 12, 2006
    #3
  4. theridges

    theridges Guest

    so you soldered it in.....check the lpc and all your solder poiints...
     
    theridges, Sep 12, 2006
    #4
  5. triniboy1

    triniboy1 Member

    Joined:
    Sep 11, 2006
    Messages:
    3
    Likes Received:
    0
    Trophy Points:
    11
    I've checked them a number of times and they seem to be fine... would the Xenium OS sill boot if there was a problem with a solder joint?
     
    triniboy1, Sep 13, 2006
    #5
  6. theridges

    theridges Guest

    it could be a number of problems, check teamxodus.com forums they probably know what is wrong....
     
    theridges, Sep 13, 2006
    #6

Share This Page