Eurovox flashing step by step.

funkyfive

Unplug the Eurovox, Press download on the UFL, when it says waiting for the response of your receiver wait a few sec's then plug the EV back in.

Many take a few attempts.

 

HiTeck,
When you say unplug the eurovox I take it you just mean from the mains supply and not unplug the null modem.I have unplugged the box from the mains and when I get to the bit with receiver not detected and if you want to download the firmware in boot mode press ok below and AC power on your receiver I pressed ok and when I plug the box back in the 4 lines come up and then 4 zeros.I have tried about 30 times without success and by that I mean going back to the start each time,unplugging the box and then downloading UFL and then plugging back in. Anything else I could do?
Sorry for the hassle but i am trying to fix this for an old pensioner who likes a bet on the horses.

 

yeah everything you said i've already done simbol rate at 6.952,the quality is good but still says sevice unknown

 

Where abouts are you, whos your provider. are any channels working.

 

apologies for the delay had to go to work,

Yes should of said the mains.

If you have done other box's without problems unless somethings changed on your pc you should not be having this problem.
When flashing the box keep it on standby, are you using the same cable as before with other box's.

 

HiTeck, Tried 3 different cables and also 2 different computers.Just wondered if anyone had come across this problem or knew of a way to fix it.

 

If you go to device manager then click the + at the side of com ports with the cable pluged in is it throwing up any yellow question marks.

 

No yellow question marks and when I check the device it comes up working properly

 

evening HiTecK,had something like this myself,it was a problem with the serial port on the box,i had to hold the cable in firmly till the download finished,worth a go.

 

I'll give that a try karljd

 

evening Karl, yeah definatley worth a try, not come accross this where works ok for one box and not the other on the same pc,

congrats on the new status karl.

also look here from sc0user, may require jtag.

http://forums.afterdawn.com/thread_view.cfm/8/653745#3991470

 

karljd,
Tried that but no joy.I maybe take the back off it tomorrow and see if there are any loose connections going to the port on the eurovox.thanks for you and HiTecks help.

 

Sorry folks on holliers hope all is well, congrats Karl

 

i'm in west dunbartionshire,vir**n is my supplier,no channels that i can see work,my mate has the same box and his is the same,the newer boxes work ok just the old 1's not to hot.

 

thanks sc0ucer hope you enjoying your hol,and hope its somewhere nice and sunny

 

what old box are you talking about doogieh?
congrats Karl
enjoy the hols scouse, wish i was back on them again, went too fast!

 

blue box about two years old

 

are you asking for help or stating something doogieh? as the 2006 picks the same channels ect as the 2008?

 

i cannot find where to put the null cable. out of the only 2 places the first one is for my monitor and the second says do not remove, can anyone tell me what i nned to get my eurvox to work and where i can buy a null cable with a usb connection? Thanks.

 

Page one of this thread,try maplins or if you want a cheap one fleabay.