kryptview 780 box keeps going off

and what about swapping boxes over

 

what do u mean swap the boxes over and what channel is is it best left on standby on

 

put the krypt upstairs and starview downstairs or vice versa
and on standby instead of knocking box off at night by switch, just press power button on remote your channels should be still there in morning

 

we only get basic channels on the starview box mate,we do press the power button on the remote and then it goes into power saving mode

 

but when you press the power button on krypt remote at night
does it still leave you with a blank screen next morning

 

sometimes its ok but this morning it just went to the installation page

 

as jodav said no point in saying reflash again
did you do a factory reset after you reflashed
id just leave it on stand by for a few days and see what happens then
also make sure everything in settings is ok
if problem still happens i really cant advise much more on the prob as its the first time ive heard of this happening
you could try the supplier and see what he says on the matter!

 

no did'nt do a reset ,i am gonig to have another go tonight and see what happens .i do have the box on a cable with splitters on it so i will try and do it from the main cable into the house .thanks for your help mate.

 

hope it works out for ya

 

well he must be going for a record he on 3 forums now with the same problem lol and posting the same stuff

 

can i ask whats the problem?me asking questions does it hurt you at all mate

 

nope but you are been stupid stick to one forum and get the bloody thing sorted

with all the fecking messing around you would well have it sorted by now if you had done what you where asked to do and letting us know what you had connected this problem is all down to yourself and i would very much doubt its a box problem

you have not said once what firmware you even have on the box what your signal leavels are all these are needed there is no point going to other forums and saying my 780 has lost channels went back to installation menu have you even done a factory default on your box huh whats that ? how do i do that if you had followed the tutorial i gave you in the first place your box would be working you are the only one having this problem out of all the forums not 1 other post have i seen with this problem

defo down to user error without a doubt in the world

 

Good luck from me2 bud, splitters should have nothing at all to do with your problem, as you have described it, that woulld give you completely different issues.

 

dont know why he dont just dump the starview and just use the a780 whats the point of having something plugged in when you get more channels off of a freeview tv than a sv thats down due to n3 probably cure his problem at the same time